Briggs & Stratton 3200 PSI / 220 BAR - Manual (Page 7)

ASSEMBLY
7
ASSEMBLY
IMPORTANT: Read entire operator’s manual before you
attempt to assemble or operate your new pressure washer.
Unpack the Pressure Washer
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main unit
• High pressure hose
• Spray gun with quick connect fitting
• Nozzle extension with quick connect fitting
• Handle
• Parts Bag (includes the following):
• Hose fittings
• Quick connects
• Bag containing 5 multi–colored quick connect spray
tips
• Safety goggles
• Operator’s manual
• Engine operator’s manual
• Maintenance kit
• Handle fastening hardware kit (which includes):
• Carriage bolts (2)
• Plastic knobs (2)
If parts are missing or damaged, contact the local Briggs &
Stratton service center.
PREPARING PRESSURE
WASHER FOR USE
To prepare your pressure washer for operation, you
will need to perform these tasks:
1.
Attach handle to main unit.
2. Verify oil dipstick has been installed into pump (Figure 2).
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle
NOTE: All assembly operations given in this section will
be described from the perspective of assembling the
pressure washer from the rear.
1. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 3).
Align Holes
Handle
Handle
Supports
Figure 3 — Attach Handle to Base
Figure 2 — Pump Dipstick
Pump Oil Dipstick