Troubleshooting – Philips Wake-up Light User Manual

Page 13

Advertising
background image

Specifications

Rated voltage

230V

Rated frequency

50Hz

Rated input

100W

Insulation class

II

Ingress of water

IPX0

Operating conditions

Temperature

from +10°C to +35°C

Relative humidity

from 30% to 90%

Storage conditions

Temperature

from -20°C to +50°C

Relative humidity

from 30% to 90% (no

condensation)

Circuit diagrams, parts lists and other technical descriptions will be provided on request.

Take measures to prevent the occurrence of electromagnetic interference or other types of

interference between this appliance and other appliances.

troubleshooting

This chapter summarises the most common problems you could encounter with the appliance. If

you are unable to solve the problem with the information below, contact the Consumer Care

Centre in your country.

Problem

Solution

The appliance does

not work.

Perhaps you have not inserted the plug properly into the wall socket. Put

the plug properly into the wall socket.
Perhaps there is a power failure. Check if the power supply works by

connecting another appliance.
Perhaps the mains cord is damaged. If the mains cord is damaged, you

must have it replaced by Philips, a service centre authorised by Philips or

similarly qualified persons in order to avoid a hazard.
Perhaps the appliance overheated and the overheating protection

switched off the appliance. Remove the cause of overheating (e.g. a

towel that blocks one or more vents) and unplug the appliance. Wait

approx. 20 minutes and then put the plug back into the wall socket.

The appliance

becomes hot during

use.

This is normal, as the appliance is heated up by the light of the lamp.

The appliance does

not respond when I

try to set different

functions.

Press the Reset button in the bottom of the appliance or remove the

plug from the wall socket and reinsert it. The appliance is then reset to

the factory default settings.

The light does not go

on when the alarm

goes off.

Perhaps you set the light intensity level too low. Turn the light intensity

wheel @ to a higher light intensity level.

EnglisH

1

Advertising
This manual is related to the following products: