Philips SHAVER Series 3000 afeitadora eléctrica en seco - Manual (Page 9)

4 Remove the shaving heads and place new ones in the shaving unit.
5 Put the retaining frame back into the shaving unit, push it down (1)
and turn the wheel clockwise (2).
6 Put the shaving unit back onto the shaver.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country.
Problem Possible cause Solution
Reduced shaving
performance.
The shaving heads are dirty. You
have not cleaned the shaver
well enough or you have not
cleaned it for a long time.
Clean the shaver thoroughly before you
continue shaving. See chapter ‘Cleaning and
maintenance’.
Long hairs obstruct the shaving
heads.
Clean the cutters and guards with the cleaning
brush supplied. See chapter ‘Cleaning and
maintenance’, section ‘Every two months:
shaving heads’.
The shaving heads are damaged
or worn.
Replace the shaving heads every 2 years
for optimal shaving results. See chapter
‘Replacement’.
The shaver does
not work when
I push the on/off
slide upwards.
The shaver is not connected to
the mains.
Put the mains plug in the wall socket.
Skin irritation. Your skin needs time to get
used to the Philips shaving
system.
Skin irritation during the first 2-3 weeks of use
is normal. After this period, the skin irritation
usually disappears.
EnglisH 9