Brother DCP 8060 - Manual (Page 72)

60
Dust on Drum
The primary corona wire on the
drum unit needs to be cleaned. Clean the primary corona wire on the drum unit.
(See Cleaning the corona wire on page 71.)
Fuser Error
The temperature of fuser unit does
not rise at a specified temperature
within specified time. Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on.
The fuser unit is too hot.
No Paper
The machine is out of paper or
paper is not properly loaded in the
paper tray. Do one of the following:
„ Refill the paper in the paper tray or MP tray.
„ Remove the paper and load it again.
No Tray
The paper tray is not completely
closed. Close the paper tray properly.
Out of Memory
The machine’s memory is full. Copy operation in progress
Do one of the following:
„ Press Start to copy the scanned pages.
„ Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Printing operation in process
Do one of the following:
„ Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the
CD-ROM.)
„ Clear the data from the memory by pressing
Job cancel.
Paper Jam
Back
The paper is jammed in the back of
the machine. (See Paper jams on page 63.)
Paper Jam
Duplex
The paper is jammed in the duplex
tray. (See Paper jams on page 63.)
Paper Jam
Inside
The paper is jammed inside the
machine. (See Paper jams on page 63.)
Paper Jam
MPTray
The paper is jammed in the MP tray
of the machine. (See Paper jams on page 63.)
Paper Jam
Tray1
Paper Jam
Tray2
The paper is jammed in the paper
tray of the machine. (See Paper jams on page 63.)
Replace Fuser
It is time to replace the fuser unit. Call Brother Customer Service to replace the
fuser unit.
Replace Laser
It is time to replace the laser unit. Call Brother Customer Service to replace the
laser unit.
Replace PF
Kit1
It is time to replace the paper
feeding kit for Tray 1. Call Brother Customer Service to replace the
PF Kit 1.
Error Message Cause Action