Bosch CCS180 - Manual (Page 11)

-11-
Disconnect battery pack from tool. Loosen the
depth adjustment lever located on the right
side of the tool. Hold the foot down with one
hand and raise or lower saw by the handle. Tighten lever at the depth setting desired.
Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
SAFETY SWITCH
The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 5). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate. (See Switch & General Cuts
on page 12.)
90° CUTTING ANGLE CHECK
Disconnect battery pack from tool. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on quadrant,
retighten lever and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 6). Make adjustments by
turning the small alignment screw from bottom
side of foot, if necessary (Fig. 7).
DEPTH ADJUSTMENT
Operating Instructions
FIG. 3 FIG. 4
FIG. 5
FIG. 7 FIG. 6
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
DEPTH
ADJUSTMENT
LEVER
CALIBRATED DEPTH
BRACKET
SAFETY SWITCH
RELEASE BUTTON
ALIGNMENT
SCREW
BEVEL
ADJUSTMENT
KNOB
BLADE
TRIGGER
FOOT
BM 2610001787 07-08 7/24/08 10:42 AM Page 11