Black & Decker BLC18750DMS - Manual (Page 4)

6 7
USING YOUR BLENDER
1. Make sure appliance is oFF.
2. Place foods to be blended into jar.
3. Place lid on jar; make sure lid cap is in place.
Important: Do not remove lid while blender is running.
4. Plug power cord into standard electrical outlet.
Note: When in use, do not leave blender unattended. When using hard foods,
such as ice, cheese, nuts and coffee beans, keep one hand on lid to keep
blender in place.
5. Press PoWeR button. Select speed and function following directions below.
6. When finished, press START/SToP button. Make sure blades have
completely stopped before attempting to remove blending jar from base.
7. To remove jar, grasp handle, turn slightly
counterclockwise to unlock position and lift up
(F).
8. Remove lid to pour.
9. Always unplug appliance when not in use
USING MODE FUNCTION
When blender is plugged in and PoWeR button
is pressed, speed will be shown at 1 on display in
center of control panel and red light below SPeed
indicator light in Mode section of control panel will
flash (G).
ADJUSTING SPEEDS
1. Press / buttons below digital display in
center of control panel to select speed that best
suits your desired task. digital display will show
number of speed selected (H).
2. Press START/SToP button and blender will run
until START/SToP button is pressed again.
CUPS OZS
F
How to Use
This unit is for household use only.
GETTING STARTED
• Remove all packing material and any stickers from the product.
• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all removable parts as instructed in CARe ANd CleANING section of
this manual.
Important: This blender has an intelligent system that
automatically shuts off the appliance after  minutes
for speeds  to 8 and after 0 seconds for the PULSE
and CRUSH functions. If this occurs, the LED display
shows "EE"; unplug the unit and wait 0 seconds (C).
BLENDER JAR ASSEMBLY
1. Turn blender jar upside-down and place flat on countertop or work surface.
2. Put the gasket on top of the blade assembly.
3. Place the blade assembly with gasket in bottom opening of the jar, with
blades down.
4. Place jar base onto blending jar and rotate
clockwise until it is tight (D).
5. Turn assembled blending jar right side up.
6. Place lid with lid cap on blending jar.
7. Uncoil power cord from storage area under base.
8. Place jar in unlocked position on base and turn jar
clockwise until jar is in locked position on base (E).
9. Blender is now ready for use.
G
E
CUPS OZS
D
EE
C
ENGLISH
1
H