Philips HAIRCLIPPER Series 9000 cortapelos - Manual (Page 3)

2 Switch on the appliance.
3 Hold the appliance with the cutting unit pointing
upwards and make downward strokes with the
precision trimmer (the narrow side of the cutting
unit).
Be careful, the trimmer removes every hair it touches.
Cleaning
Clean the appliance every time you have used it.
Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as alcohol, petrol or acetone to
clean the appliance.
Only clean the appliance and the adapter with the
cleaning brush supplied.
Note: This appliance does not need any lubrication.
1 Make sure the appliance is switched off and
disconnected from the mains.
2 Pull the comb off the appliance (Fig. 10).
3 Clean the cutting unit with the cleaning brush
supplied. Also brush away any hairs that have
collected in the openings under the cutting
unit (Fig. 12).
Note: If the cutting unit falls off the appliance, you can
reattach it. Place the cutting unit back onto the appliance
and press it down until you hear it lock into position with
TWO clicks.
storage
1 Put the appliance in the storage case supplied.
2 Store the appliance in a safe and dry place.
Note: Do not store the appliance while it is still connected to
the mains.
Environment
- Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. (Fig. 13)
- The built-in rechargeable battery contains substances
that may pollute the environment. Always remove
the battery before you discard and hand in the
appliance at an official collection point. Dispose of
the battery at an official collection point for batteries.
If you have trouble removing the battery, you can
also take the appliance to a Philips service centre.
The staff of this centre will remove the battery for
you and will dispose of it in an environmentally safe
way (Fig. 14).
Removing the rechargeable battery
Only remove the rechargeable battery if it is completely
empty.
Do not connect the appliance to the mains again after
you have opened it.
1 Disconnect the appliance from the mains and let
the appliance run until the motor stops.
2 Pull the cutting unit off the appliance.
3 To remove the front panel, insert a screwdriver
between the front panel and the appliance (Fig. 15).
4 Undo the screw behind the front panel (Fig. 16).
5 Insert a screwdriver between the front housing and
the back housing of the appliance (Fig. 17).
6 Remove the entire front housing (Fig. 18).
7 Undo the four screws that fasten the printed circuit
board (Fig. 19).
8 Pull out the printed circuit board with rechargeable
battery (Fig. 20).
9 Cut the wires that connect the printed circuit
board with rechargeable battery to the
motor (Fig. 21).
Guarantee and service
If you need service or information or if you have a
problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number
in the worldwide guarantee leaflet). If there is no
Consumer Care Centre in your country, go to your local
Philips dealer.
3 4222.002.8063.1