Philips SHAVER Series 3000 afeitadora eléctrica en seco - Manual (Page 12)

Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The shaver does
not shave as well
as it used to.
The shaving heads are
damaged or worn.
Replace the shaving heads (see chapter
‘Replacement’).
Long hairs obstruct the
shaving heads.
Clean the shaving heads one by one (see section
‘Cleaning the shaving unit with the cleaning brush’
in chapter ‘Cleaning and maintenance’).
You have not inserted the
shaving heads properly.
Make sure that the projections of the shaving
heads fit exactly into the recesses (see
chapter ‘Replacement’).
The shaver does
not work when I
press the on/off
button.
The temperature of the
shaver is too high. In this
case, the shaver does not
work.
As soon as the temperature of the shaver has
dropped sufficiently, you can switch on the shaver
again.
You have not connected
the shaver to the mains. This
shaver can only be used
directly from the mains.
Put the small plug in the shaver, put the adapter in
the wall socket and press the on/off button again.
Water leaks from
the shaver after
cleaning.
This is normal and not
dangerous.
During rinsing some water may collect between
the power unit and the housing. After rinsing this
water flows out through the socket. The power unit
is completely watertight so water cannot reach the
electronic parts of the shaver. Your shaver continues
to be absolutely safe.
English
12