Philips PowerPro Duo Aspirador vertical 2 en 1 sin cable - Manual (Page 8)

Troubleshooting
This chapter summarises the most common problems you could encounter with your appliance. If
you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Philips Consumer Care Centre in your country.
Problem Cause Solution
The appliance does
not work when I
push the button.
The battery light flashes fast
because the batteries are low.
To charge the batteries, insert the small
plug into the socket on the appliance and
insert the adapter into a wall socket.
You cannot use the appliance
because the appliance is still
charging.
You have to remove the small plug from
the socket on the appliance before you
can switch on the appliance.
You have to press two buttons. First press the on/off button to switch
on the appliance. Then press the MAX
button to get maximum suction power.
The vacuum cleaner
has a lower suction
power than usual.
The filter and the cyclone are
dirty.
Clean the filter and the cyclone.
You have not connected the
dust bucket, the dust separator
and the cyclone properly.
Incorrect assembly of these
parts causes air leakage, which
leads to loss of suction power.
Connect the dust bucket, the dust
separator and the cyclone properly.
Dust escapes from
the vacuum cleaner.
The filter is dirty. Clean the filter.
The brush does not
turn anymore.
The brush has encountered too
much resistance.
Clean the brush.
You switched on the appliance
by pressing the on button on
the handheld vacuum cleaner.
Switch off the appliance by pressing the
on button on the handheld vacuum
cleaner again. Then switch it on again by
pressing the on button on the stick.
ENGLISH 8