Bosch LTC 2821 - Manual (Page 10)

LTC 2821/91 | Instruction Manual | Controls & Connections
Bosch Security Systems | November 2003
EN | 10
5.2 Rear Panel
See FIGURE 2 for location of rear panel connectors.
VIDEO LINE
VIDEO A IN/OUT
IN: Video signal input terminal.
OUT: Passive loop-through video signal output
terminal (auto termination).
NOTE: For corresponding audio signal, use the
AUDIO A terminals.
VIDEO B IN/OUT
IN: Video signal input terminal.
OUT: Passive loop-through video signal output
terminal (auto termination).
NOTE: For corresponding audio signal, use the
AUDIO B terminals.
VCR IN: Video signal input terminal.
NOTE: For corresponding audio signal, use the
AUDIO IN VCR terminal.
AUDIO LINE
AUDIO A IN/OUT
IN: Audio signal input terminal.
OUT: Loop-through audio signal output terminal.
NOTE: For corresponding video signal, use the
VIDEO A terminals.
AUDIO B IN/OUT
IN: Audio signal input terminal.
OUT: Loop-through video signal output terminal.
NOTE: For corresponding video signal, use the
VIDEO B terminals .
AUDIO IN VCR: Audio signal input terminal.
NOTE: For corresponding video signal, use the VCR
IN terminal .
AC IN
Power input connector. Connects the supplied
AC power cord to the appropriate AC outlet.
NOTE:
The impedance is automatically set to 75 ohms
by the input of a signal on the input connector
while operating in a single connection mode.
However, if a cable is connected to the output
connector, the connection is placed into the
open status by the multiple connection and
high impedance automatically selected. Do not
leave an unused cable connected to the
monitor. If a single cable is used, then it must
be connected to the input connector for the 75
ohms auto termination selector to function
properly.
Figure 2: Location of Rear Connectors