Brady 2034 - Manual (Page 61)

_____________________________________________________________________________________________________
Maintenance and Adjustments 55
3) The media slips or does not properly advance:
Possible cause and solution:
•
The Head Level Adjustment Knob setting is adjusted too high, re-
adjust the Head Level Adjustment Knob, (see Section 5.3.1).
•
The Platen Roller is dirty, clean the Platen Roller.
4) Uneven printing or print too light:
Possible cause and solution:
•
The Hinge Plate is open or unlatched, re-latch the hinge plate, (see
Section 5.1, steps 6, 7, and 8).
•
The Head Level Adjustment Knob setting is adjusted too high, re-
adjust the head level adjustment knob, (see Section 5.3.1).
•
The darkness is adjusted too low, readjust.
5) Poor print quality:
Possible cause and solution:
•
The Printhead is dirty, clean the printhead, (see Section 5.1).
•
The wrong ribbon/paper combination is being used, use a different
type of ribbon and/or paper.
•
The Printhead temperature is too high or too low. Use software control
to adjust the heat settings or darkness via the optional LCD/Keypad
Front Panel.
•
The Printhead is bad, ( see Section 5.3.3).
6) No display
−−
power light is on (LCD/Keypad front panel):
Possible cause and solution:
•
Display contrast set too low, turn the contrast adjustment clockwise
until the display appears.
•
The LCD display is defective, return the Printer for service.