Belkin P74080 - Manual (Page 7)

ASSEMBLING YOUR DRIVE ENCLOSURE
3
1. Remove top of the External Drive.
2. If you are installing a 3 1 /
2
-inch hard drive, check to make
sure your drive is set to “Master” (see jumper setting
information printed on top of your disk drive), then
connect the 34-position data cable and 4-position
power cable.
3. If you are installing a CD/CD-RW drive, check to make
sure your drive is set to “Master”, then connect the
34-position data cable, 4-position power cable, and
4-position audio cable.
4. Choose the set of mounting holes that match the drive
you intend to use, and install at least four of the provided
mounting screws.
P74080-F5U209-man_8-02.qxd 8/26/02 12:36 PM Page 3