Bay Technical Associates 529H User Manual
Page 37
32
!
By responding to the Enter Request: message at the end of the main
configuration menu (see
Section 6.1
) with "
6
" (Set Mode of
Operation), you may change the current mode of operation. The
multiport will respond with:
MODE OF OPERATION
Full Duplex Communication...................1
All Messages from All Ports.................2
Single Message from All Ports...............3
All Messages from Selected Port.............4
Single Message from Selected Port...........5
Time Division Multiplexer...................6
Exit........................................X
Current Mode is: 1
Enter request:
You may now enter the mode of operation that you wish. The
multiport will respond with:
Save Changes Permanently? (Y/N):
If you answer "
Y
" (yes), the new mode will be saved in non-volatile
memory and will become the new power-up mode. If you answer "
N
"
(no), the new mode of operation will be stored in RAM and will be lost
upon next power-up. The multiport will now return to the main
configuration menu (see
Section 6.1
).
"
By responding to the Enter Request: message at the end of the main
configuration menu (see
Section 6.1
) with capital "
X
" (Exit), you will
exit the configuration mode and return to the operation mode.