Philips Rasoir électrique - Manual (Page 2)

ENGLISH
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that Philips
offers, register your product at www.philips.com/
welcome.
Important
Read this user manual carefully before you use the
appliance and save it for future reference.
Warning
- This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that
they do not play with the appliance.
Caution
- Keep the appliance dry (Fig. 1).
- Use and store the appliance at a temperature
between 15°C and 35°C.
- Remove the batteries from the appliance if you
are not going to use it for a month or more.
Compliance with standards
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this
user manual, the appliance is safe to use based on
scientific evidence available today.
Preparing for use
Inserting batteries
The appliance runs on two R6 AA 1.5-volt
batteries. Preferably use Philips alkaline batteries.
Make sure that your hands are dry when you
insert the batteries.
1 Remove the lid of the battery
compartment (Fig. 2)
2 Place two batteries in the battery
compartment (Fig. 3).
Note: Make sure the + and - indications on the
batteries match the indications in the battery
compartment.
Note: The shaver does not work if the batteries have
been placed incorrectly.
3 Put the lid of the battery compartment back
onto the appliance. First insert the top part of
the lid (1) and then press down the bottom
part (2) until you hear a click (Fig. 4).
How to avoid damage due to battery
leakage
- Do not expose the appliance to temperatures
higher than 35°C.
- Remove the batteries if you are not going to
use the appliance for a month or more.
- Do not leave empty batteries in the appliance.
Shaving time
Two new batteries offer a shaving time of 60
minutes.
Using the appliance
Shaving
Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
Shaving on a dry face gives the best results.
1 Push the on/off slide upwards to switch on
the shaver (Fig. 5).
2 Move the shaving heads over your skin. Make
both straight and circular movements (Fig. 6).
3 Push the on/off slide downwards to switch off
the shaver.
4 Put the protection cap on the shaver after
use to prevent damage to the shaving
heads (Fig. 7).
Cleaning and maintenance
Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as petrol or acetone to
clean the appliance.
Regular cleaning guarantees better shaving
performance.
For easy and optimal cleaning, Philips Shaving Head
Cleaning Spray (type no. HQ110) is available. Ask
your Philips dealer for information.
Note: Philips Shaving Head Cleaning Spray may not
be available in all countries. Contact the Consumer
Care Centre in your country about the availability in
your country.
You can also clean the shaver in the following way:
Every week: shaving unit and hair
chamber
1 Switch off the shaver.
2 Clean the top of the appliance with
the cleaning brush (Fig. 8).
3 Press the release button (1) and remove the
shaving unit (2) (Fig. 9).
4 Clean the inside of the hair chamber with the
cleaning brush (Fig. 10).
5 Clean the inside of the shaving unit with the
cleaning brush (Fig. 11).
6 Put the shaving unit back onto the shaver.
Every two months: shaving heads
1 Switch off the shaver.
2 Press the release button (1) and remove the
shaving unit (2) (Fig. 9).
3 To remove the retaining frame, push the sides
of the central spring towards each other
(1). Then lift the retaining frame out of the
shaving unit (2) (Fig. 12).
4 Slide the shaving heads out of the retaining
frame (Fig. 13).
Do not mix up the cutters and the guards.
This is essential since each cutter has been
ground with its corresponding guard for optimal
performance. If you accidentally mix up the sets, it
could take several weeks before optimal shaving
performance is restored.
5 Clean the cutter with the short-bristled side
of the cleaning brush (Fig. 14).
Brush carefully in the direction of the arrow.
6 Clean the guard with the cleaning
brush (Fig. 15).
7 Slide the shaving heads back into the retaining
frame and put the retaining frame back into
the shaving unit (Fig. 16).
8 Put the shaving unit back onto the shaver.
Extra thorough cleaning
For extra thorough cleaning, put the shaving
heads in a degreasing liquid (e.g. alcohol) every six
months. To remove the shaving heads, follow steps
1 to 4 described above. After cleaning, lubricate
the central point on the inside of the guards with a
drop of sewing machine oil to prevent wear of the
shaving heads.
Replacement
Replace the shaving heads every 2 years or if they
are damaged or worn. Replace them with HQ4 Ç
Philips shaving heads only.
1 Switch off the shaver.
2 Press the release button (1) and remove the
shaving unit (2) (Fig. 9).
3 To remove the retaining frame, push the sides
of the central spring towards each other
(1). Then lift the retaining frame out of the
shaving unit (2) (Fig. 12).
4 Slide the shaving heads out of the retaining
frame and replace them with new
ones (Fig. 13).
5 Put the retaining frame back into the shaving
unit.
6 Put the shaving unit back onto the shaver.
Accessories
The following accessories are available:
- HQ4 Ç Philips shaving heads.
- HQ110 Philips Shaving Head Cleaning Spray
(not available in China).
Environment
- Batteries contain substances that may pollute
the environment. Do not throw away empty
batteries with the normal household waste,
but dispose of them at an official collection
point for batteries. Always remove the batteries
before you discard and hand in the appliance at
an official collection point.
- Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment (Fig. 17).
Guarantee & service
If you need service or information or if you have a
problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If
there is no Consumer Care Centre in your country,
go to your local Philips dealer.
Guarantee restrictions
The shaving heads (cutters and guards) are
not covered by the terms of the international
guarantee because they are subject to wear.
Troubleshooting
This chapter summarises the most common
problems you could encounter with the
appliance. If you are unable to solve the problem
with the information below, contact the Consumer
Care Centre in your country.
1 4222.002.5144.2