Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) - Manual (Page 85)

Brocade 6910 Ethernet Access Switch Diagnostic Guide 75
53-1002653-01
8
DRAFT: BROCADE CONFIDENTIAL
Trunking
Port Channel 1 neighbors
------------------------------------------------------------------------------
Eth 1/11
------------------------------------------------------------------------------
Partner Admin System ID : 32768, 00-00-00-00-00-00
Partner Oper System ID : 32768, 00-E0-0C-00-00-FA
Partner Admin Port Number : 11
Partner Oper Port Number : 3
Port Admin Priority : 32768
Port Oper Priority : 32768
Admin Key : 0
Oper Key : 3
Admin State : defaulted, distributing, collecting,
synchronization, long timeout,
Oper State : distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity
. . .
show lacp sysid
Syntax: show lacp sysid
This command displays a summary of the system priority and MAC address for all channel groups.
Command output resembles the following example.
Console# show lacp sysid
Port Channel System Priority System MAC Address
------------------------------------------------------------------------------
1 32768 70-72-CF-32-DD-FD
2 32768 70-72-CF-32-DD-FD
3 32768 70-72-CF-32-DD-FD
4 32768 70-72-CF-32-DD-FD
5 32768 70-72-CF-32-DD-FD
6 32768 70-72-CF-32-DD-FD
7 32768 70-72-CF-32-DD-FD
8 32768 70-72-CF-32-DD-FD
9 32768 70-72-CF-32-DD-FD
10 32768 70-72-CF-32-DD-FD
11 32768 70-72-CF-32-DD-FD
12 32768 70-72-CF-32-DD-FD
Configuration notes
There are several trunk group rules. For a full description of these trunking rules, refer to the
Brocade 6910 Ethernet Access Switch Configuration Guide.
• You can use both static trunk groups and 802.3ad trunking on the same device. However, you
can use only one type of trunking for a given port. For example, you can configure port 1/1 as
a member of a static trunk group or you can enable 802.3ad link aggregation on the port, but
you cannot do both.
• The ports in a trunk group make a single logical link. Therefore, all the ports in a trunk group
must be connected to the same device at the other end.
• If you connect physical cables before configuring the trunk groups and then reboot, traffic on
the ports can create a spanning tree loop.