Philips Lumea Épilateur à lumière intense pulsée - Manual (Page 38)

Problem Possible
cause
Solution
I have
switched on
the appliance
but I cannot
crease or
decrease the
light intensity.
The
appliance has
to be reset.
To reset the appliance, switch off
the appliance and then switch it
on again.
If you still cannot adjust the light
intensity, contact the Consumer Care
Centre in your country, your Philips
dealer or a Philips service centre.
The ‘ready
to flash’ light
does not go
on when I
place the
appliance on
the skin.
You have not
put the body
attachment
with safety
ring properly
on the skin.
Place the appliance at a 90° angle
onto the skin in such a way that all
contact switches touch the skin.
Then check if the ‘ready to flash’ light
is on and press the flash button.
If this does not work, place the
appliance on a part of your body
where it is easy to establish full skin
contact, for example on your lower
arm.Then check if the ‘ready to flash’
light works. If the ‘ready to flash’ light
still does not go on when you place
the appliance on the skin, contact
the Consumer Care Centre in your
country,
your Philips dealer or a Philips service
centre.
English 38