Philips tondeuse cheveux familiale - Manual (Page 9)

4 Slide the on/off slide upwards to switch on the appliance.
5 Place the hair clipping comb on the scalp and move the appliance
through the hair slowly.
Tips
- Start clipping at the highest length setting of the hair clipping comb and
reduce the length setting gradually.
- Write down the length settings you have used to create a certain
hairstyle as a reminder for future clipping sessions.
- To clip in the most effective way, move the appliance against the
direction of hair growth.
- Since hair grows in different directions, you need to move the appliance
in different directions as well (upward, downward or across).
- Make overlapping passes over the head to ensure that the appliance
catches all the hairs that need to be cut.
- Make sure that the flat part of the hair clipping comb is fully in contact
with the scalp to obtain an even clipping result.
- To achieve a good result with curly, sparse or long hair, you can use a
styling comb to guide the hair towards the appliance.
- Regularly remove cut hair from the hair clipping comb. If a lot of hair
has accumulated in the comb, remove it from the appliance and blow
and/or shake the hair out of it.
Clipping without hair clipping comb
You can use the appliance without hair clipping comb to clip your hair very close
to the skin (0.5mm) or to contour the neckline and the area around the ears.
1 To remove the hair clipping comb, press the length setting selector
(1), move the comb upwards and then pull it off the appliance (2).
2 Comb the hair ends over the ears before you start to contour the
hairline.
3 Slide the on/off slide upwards to switch on the appliance.
ENGLISH 9