Connections, Connecting a s-video or video source to port 2, Adjust – Barco R9002120 User Manual
Page 17: Enter, Exit, Press, Key. select 'random access' and press, Select 'selected source' and press, Highlight 'picture tuning' and press, Highlight 'port 2 : video' and press
Connections
3 - 3
5975977 BARCODATA 708 260597
Connecting a S-Video or Video source to port 2.
Separate Y-luma/C-chroma signals for higher quality playback of
Super VHS signals.
COMM PORT
(800 peripherals)
REMOTE
S
VIDEO
S-VIDEO
VCR S-VHS
Audio amplifier
Luma/Chroma
R
G(S)
B
R-Y
Y(S)
B-Y
RS232 OUT
RS232 IN
If a line doubler is built in :
the default position of this line doubler is ON (active), the video
input signal will be displayed as a non interlaced image (=
improved image stability).
To enable or to disable this line doubler function, enter the
adjustment mode and change the position of the ON/OFF
toggle switch (see Picture tuning in chapter 'Guided' adjust-
ment mode or 'Random access' adjustment mode).
Input selection
a. with the RCU : press digit button 2 or
b. with the local keypad.
(for access to the local keypad, see Local keypad in chapter
Location and function of controls.)
- press
ADJUST
key, the General access menu is displayed on the
screen.
- use the control disk to highlight
2
.
- press
ENTER
to select the highlighted source.
GENERAL ACCESS
Select with ,
or
then <ENTER>.
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5 6
3 4
1
2
Enter ADJUST
Select with or
then <ENTER>
<EXIT> to return.
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
Source 02
Select with or
then <ENTER>
<EXIT> to return.
Choose a setup pattern
from below :
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Source 02
Select with or
then <ENTER>
<EXIT> to return.
RANDOM ACCESS
ADJUSTMENT MODE
PICTURE TUNING
GEOMETRY
CONVERGENCE
FOCUSING
COLOR SELECT
ORBITING
CONTR. MODULATION
SOFT EDGE
Select with or
<ENTER> to accept
<EXIT> to return.
PICTURE TUNING
COLOR BALANCE
SYNC : FAST
PORT2 : S-VIDEO
LINE DOUBLER : ON
Depending on the priority setting in the 'Picture Tuning menu', Video
or S-Video can be displayed.
If the setting is not correct, start up the adjustment mode by pushing
on the
ADJUST
key.
Select 'Random Access' and press
ENTER
.
Select 'Selected source' and press
ENTER
.
Highlight 'Picture Tuning' and press
ENTER
.
Highlight 'Port 2 : Video' and press
ENTER
to toggle between VIDEO
and S-VIDEO.
Press
EXIT
to return.
Press
ADJUST
to return to operational mode.