Bosch TS2000 - Manual (Page 6)

For Mounting Bosch 4100/4000
Table Saw to Stand
1. Using the diagram on page 7 (figure H),
locate the Bosch 4100/4000 mounting
holes and position saw on stand as shown
in figure G.
2. To mount the 4100 Table Saw:
Align the saw as shown in figure F. Place
one (1) 6 mm flat washer onto one (1) 6
mm x 90 mm hex head bolt and insert bolt
through mounting hole in table saw and
through stand table top.
To mount the 4000 Table Saw:
Align the saw as shown in figure G. Place
one (1) 6 mm flat washer onto one (1) 6
mm x 75 mm hex head bolt and insert bolt
through mounting hole in table saw and
through stand table top.
3. Place one (1) 6 mm flat washer and
securely tighten with one (1) 6 mm lock
nut.
Repeat this procedure on the three remaining
mounting holes.
-6-
Assembly
FIG. G
FIG. F