Buffalo Technology Buffalo AirStation WLAR-L11-L - Manual (Page 12)

WLAR-L11-L Internet Connection Manual 10
Refer to the AirStation Settings section.
5
Select TCP/IP and click the Properties but-
ton.
6
Click the IP Address tab. Then select the
Specify an IP Address and enter the follow-
ing values.
IP address: 192.168.0.2
Subnet mask: 255.255.255.0
Click the OK button.
If the LAN network has already
been configured using the TCP/IP proto-
col, input the IP address of the same net-
work address.
Check if the LAN network has already been configured using the TCP/IP protocol
according to the following procedure.
1) Click the Start button, and then select Run....
2) Enter "WINIPCFG" in the name field, and then click the OK button.
3) Change the adapter name to the LAN board name to be used.
4) If either one of the following is displayed in the IP Address field, no LAN network has
been configured using the TCP/IP protocol.
"0.0.0.0."
"169.254.x.x."
7
Restart Windows Me/98/95.
The TCP/IP protocol is set to the settings PC.
KPVGTPGVDQQM  TVR ''''և''''̙ ߆̙ 'ވ'