Brother TOWERFEED IU 683 / 0402 - Manual (Page 10)

IU 683 / 0404 8 TowerFeed TM for Brother Printers
INSTALLATION
TowerFeed Setup
TowerFeed is factory preset for the Brother HL-7050 printer. Therefore, it is not necessary to run the TowerFeed
setup program for this printer type.
Printer Setup
The TowerFeed Option must be selected using the printer panel as following:
•
Press and hold the GO button and press the Set button once. The Display will now show HIDDEN PANEL
TOWERFEED ON/OFF.
•
Press the + or – buttons as many times until the display shows 'TowerFeed ON/OFF'.
•
Press SET to enter into this menu item and press + or - until 'TowerFeed=ON' appears.
•
Press SET.
•
Press GO.
Now the printer performs a selftest and after this TowerFeed should do a short beep (reset beep of
TowerFeed). The option TowerFeed is activated now.
The Interface should be checked/selected using the printer panel (standard setting):
•
Press the + button as many times until the display shows --MENU-- INTERFACE
•
Press SET once (SELECT INTERFACE)
•
Press SET once
•
Navigate to the display SELECT =AUTO using the buttons + or -.
•
Press SET once
•
Press the button BACK twice, the display should show READY.