Brother DCP-130C - Manual (Page 19)

Installing the Driver & Software
17
Macintosh
®
M
a
c
int
os
h
®
US
B
For USB Interface Users
(For Mac OS
®
X 10.2.4 or greater)
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4-11.
Note
For Mac OS
®
X 10.2.0 to 10.2.3 users, upgrade to
Mac OS ® X 10.2.4 or greater. (For the latest
information for Mac OS
®
X, visit
http://solutions.brother.com)
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Connect the USB cable to the USB socket
marked with a
symbol. You will find the
USB socket inside the machine on the right as
shown below.
3
Carefully guide the USB cable into the trench
as shown below, following the trench around
and toward the back of the machine.
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
4
Lift the scanner cover to release the lock ( ).
Gently push the scanner cover support down
( ) and close the scanner cover ( ).
Note
Make sure that the machine is turned on by
connecting the power cord.