Philips Télécommande universelle - Manual (Page 4)

2.2 Testing the remote control
The remote control has been programmed to operate most Philips
devices. Because the SRU 5130 may use different signals for each brand
and even for different models of the same brand, it is advisable to test
whether your device responds to the SRU 5130.The example below (TV)
instructs you how to do this.You can repeat the same steps for other
devices (Set Top Box, DVD player/recorder or VCR) which you want to
operate using the SRU 5130.
Example of TV:
Turn your TV on manually or use the original remote control.Tune to
channel 1.
Press the TV key to select TV.
• The key lights up.
• If the key does not light up, check whether the batteries are
properly inserted (see ‘2.1 Inserting the batteries’).
Check whether all the keys are working.
For an overview of the keys and their functions see
‘3. Keys and functions’.
• If the TV responds as it should to all of the key commands the SRU 5130
is ready for use.
Tip
If the device does not respond at all or not to all of the key commands,
follow the instructions under ‘2.3 Setting the remote control’, or for online
setup go to: www.philips.com/urc.
2.3 Setting the remote control
This is only necessary if your device does not respond to the SRU 5130.
If that is the case, the SRU 5130 does not recognize the brand and/or
model of your device and you need to program the remote control to do
so.The example below (TV) instructs you how to do this.
You can repeat the same steps for other devices (Set Top Box, DVD
player/ recorder or VCR) which you want to operate using the SRU 5130.
3
3 3
2
2
2
1
4
Installing the remote control
ENGLISH