Belkin G Wireless Modem Router PM01218ea F5D7634-4 - Manual (Page 58)

56
G Wireless Modem Router
sections table of contents 1 2 3 4 5 7 8 9 10
ManUallY ConfIGURInG neTWoRK adaPTeRs
6
setting up your Computers
In order for your computer to properly communicate with your Router, you will need to change your computer’s “TCP/IP/Ethernet” settings to “Obtain
an IP address automatically/Using DHCP” This is normally the default setting in most home computers
You can set up the computer that is connected to the ADSL modem FIRST using these steps You can also use these steps to add computers to your
Router after the Router has been set up to connect to the Internet
1 Click “Start”, “Settings”, then “Control Panel”
2 Double-click on the “Network and dial-up connections” icon
(Windows 2000) or the “Network” icon (Windows XP)
3 Right-click on the “Local Area Connection” associated
with your network adapter and select “Properties” from the
drop-down menu
4 In the “Local Area
Connection Properties”
window, click “Internet
Protocol (TCP/IP)” and click
the “Properties” button The
following screen will appear:
Windows XP, 2000, or nT
5 If “Use the following IP
address” (2) is selected,
your Router will need to
be set up for a static IP
connection type Write the
address information in the
table below You will need
to enter this information into
the Router
6 If not already selected, select “Obtain an IP address automatically”
(1) and “Obtain DNS server address automatically” (3) Click
“OK” Your network adapter(s) are now configured for use with
the Router