Philips SalonStraight Want2Move Lisseur - Manual (Page 9)

The power-on light goes on to indicate that the straightener is
heating up.
The plates heat up rapidly and are ready for use within seconds.
5 Comb or brush your hair so that it is disentangled and
smooth (Fig. ).
6 Use a comb to divide the hair into sections. Do not put too much
hair in one section.
Tip: It is better to section off the crown area and to straighten the hair
underneath first, followed by the top area.
7 Take a section that is -cm wide. Place it between the
straightening plates and press the handles of the appliance firmly
together.
8 Slide the straightener down the length of the hair for 5 seconds,
from root to hair end, without stopping to prevent
overheating (Fig. 5).
9 Repeat this process after 0 seconds until you have achieved the
desired look.
10 Let your hair cool down. Do not comb or brush it before it has
cooled down, as this could ruin the hairstyle you have just created.
Note: Always make sure the appliance is either fully extended or fully folded
when not in use.
cleaning
Never immerse the appliance in water or any other liquid, nor rinse it
under the tap.
1 Switch off the appliance and unplug it.
 Let the appliance cool down completely on a heat-resistant surface.
 Clean the appliance with a damp cloth.
,
,
EnglisH 9