Blaupunkt New Orleans MD70 - Manual (Page 8)

8
To “train” a new KeyCard in case of loss or
damage:
➮
Insert the first KeyCard and switch the
device on.
➮
Press the MENU button,
8
.
➮
Press the or button,
7
, until
“LEARN KC” appears in the display.
➮
Press the button,
7
.
“CHANGE” appears in the display.
➮
Remove the first KeyCard.
➮
Insert the new KeyCard.
“LEARN OK” appears in the display.
To leave the menu:
➮
Press the MENU button,
8
.
The radio can now be operated with the new
KeyCard.
KeyCard lost or damaged
If all the KeyCards belonging to a device are
damaged or lost, a new KeyCard will have to
be “retrained” with the device’s master code.
You will find this code in the device’s Car Ra-
dio Passport.
Keep your Car Radio Passport in a
safe place, but never in the car itself.
The instructions for this are in the section on
“Training a new KeyCard / Entering the mas-
ter code”.
Using this KeyCard, you can then “train” a
second KeyCard. Please read the section on
“Replacing / Training KeyCards”.
New KeyCards can be obtained from your
dealer.
Training a new KeyCard /
Entering the master code
If you no longer have a valid KeyCard for your
device, and would like to train a new KeyCard:
➮
Insert the new, unknown KeyCard into
the device.
➮
Close the control unit.
➮
If necessary, switch the device off.
➮
Hold down the TUNE and ST1 buttons,
>
and
4
, at the same time.
➮
Switch the device on with the main but-
ton,
2
.
“0000” appears in the display.
Enter the four-figure master code from the Car
Radio Passport as follows:
➮
Enter each of the numbers for the mas-
ter code using the and buttons,
7
, pressing until the desired number
appears in the display.
➮
To enter the next/previous digit, use the
and buttons,
7
.
➮
When the master code is correctly dis-
played, press the OK button,
5
.
If the device switches to play, the new Key-
Card has been accepted.
Visual theft protection (LED)
When the device is switched off and the Key-
Card has been removed, the power button
and the CD slot illumination can be set to flash.
This is done by setting “LED” to “ON” in the
menu.
➮
Press the MENU button,
8
.
➮
Press the or button,
7
, until either
“LED ON” or “LED OFF” appears in the
display.
➮
Press the or button,
7
, to switch
between the settings ON and OFF.
➮
Press the OK button,
5
, or the MENU
button,
8
, to leave the menu. The set-
tings are then saved.
THEFT PROTECTION