Liebherr Face shovel - Manual (Page 4)

4
Bucket options
Whether loose dirt, abrasive material or hard rock – quality and effectiveness of every
excavator job are affected by the targeted selection of the suitable bucket. Therefore,
Liebherr has designed a wide range of bucket options, which are especially suitable for an
applicable job due to the shape, material selection and technical fittings. Practical experi-
ence and continued attention to product development assure that Liebherr buckets are
always state-of-the-art technology.
Backhoe bucket
with teeth
Backhoe bucket
with cutting edge
HD-backhoe bucket
Backhoe bucket with
limited digging depth
Backhoe bucket
with clip-on cutting edge
Backhoe bucket with univer-
sal mounting bracket
Suitable for very abrasive materials due to wear
protection and side reinforcement Suitable for digging up hard ground
A backhoe bucket with teeth that can be
equipped with a cutter if required Suitable for any rapid-change systems
Optimum penetration due to low digging resistance
If the rapid-change slot of a backhoe bucket is
wider than the backhoe bucket itself, this limits the
digging depth.
For cases such as this Liebherr offers backhoe
buckets with an extended basic shape. This
increases the maximum digging depth.