Liebherr IKBP 3554 Premium BioFresh - Manual (Page 5)

When c1 is indicated in the display:
u to activate the child lock, briefly press the
SuperCool button Fig. 2 (5) .
w The child lock symbol Fig. 2 (9) shines. c flashes in the
display.
When
c0 is indicated in the display:
u to deactivate the child lock, briefly press the SuperCool
button Fig. 2 (5) .
w The child lock symbol Fig. 2 (9) goes out. c flashes in the
display.
u To deactivate the set-up mode: press On/Off button
Fig. 2 (1) .
-or-
u Wait for 5 minutes.
w The temperature is indicated again in the temperature
display.
5.2 Door alarm
If the door is open for longer than 60 seconds, the
audible warning will sound.
The audible alarm is automatically silenced when
the door is closed.
5.2.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
u Press alarm button Fig. 2 (7) .
w The door alarm is silenced.
5.3 Refrigerator compartment
The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the plate separating off the BioFresh zone and at the
rear wall. It is warmest at the top front of the compartment and
in the door.
5.3.1 Food refrigeration
u Place butter and preserves in the upper area and in the door
(see Appliance at a glance).
u Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u Always store liquids and food which is subject to odour or
taste transfer in closed containers or cover them.
u Foods which give off a large amount of ethylene gas and
delicate foods, such as fruit, vegetables, salad, should
always be stored separately or wrapped so as not to reduce
the storage life; e.g. do not store tomatoes together with
kiwis or cabbage.
u Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
u Do not store food too close together to enable good air
circulation.
5.3.2 Setting the temperature
The temperature depends on the following factors:
- the frequency of opening the door
- the room temperature of the installation location
- the type, temperature and quantity of the food
The temperature can be set from 9 °C to 3 °C, the recom-
mended temperature is 5 °C.
An average temperature of about –18 °C is reached in the
freezer compartment.*
Note
If the temperature is to be colder than 3 °C:
u set the cooling temperature to 3 °C.
u Set the BioFresh temperature to a value between b4
(slightly colder) and b1 (coldest) (see 5.4)
u For a higher temperature setting: press Up button Fig. 2 (3) .
u For a lower temperature setting: press Down button
Fig. 2 (4) .
w When the button is pressed the first time, the previously set
value is indicated, flashing, in the temperature display.
u To change the temperature in 1 °C steps: briefly press the
button.
u To change the temperature continuously: hold down the
button.
w The value is displayed flashing during the setting operation.
w The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.3.3 SuperCool
With SuperCool you switch to the highest cooling
performance to reach lower cooling temperatures.
Use SuperCool, to rapidly cool large amounts of
food.
The SuperCool function uses slightly more energy.
Cooling with SuperCool
u
Briefly press SuperCool button Fig. 2 (5) .
w The SuperCool symbol Fig. 2 (6) lights up in the display.
w The cooling temperature drops to the coldest value. Super-
Cool is activated.
w SuperCool is automatically deactivated after 12 hours. The
appliance continues to operate in the energy-saving, normal
mode.
To prematurely deactivate SuperCool
u
Briefly press SuperCool button Fig. 2 (5) .
w The SuperCool symbol Fig. 2 (6) goes out in the display.
w SuperCool is deactivated.
5.3.4 Shelves
Moving or removing shelves
The shelves have stops preventing them from being uninten-
tionally pulled out.
Fig. 3
u Lift the shelf slightly and pull forward a little.
u Adjust the height of the shelf. To do so, push the cut-outs
along the supports.
u Only a short shelf may be inserted in front of the fan. *
u In order to remove the shelf fully, place it at a slant and pull
out towards the front.
u Re-insert shelves at the required height. The stops must
face downwards and lie behind the front shelves.
Control
* Depending on model and options 5