Liebherr WKb 3212 Vinothek - Manual (Page 4)

14
Setting the temperature
Increasing the temperature
Press the Up button.
Reducing the temperature
Press the Down button.
- When pressing one of the buttons for the first time, the display
will start to flash.
- Pressing this button again enables you to change the temperature
setting.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature will be displayed.
Operating and control elements
1 Temperature display
2 Temperature setting buttons
3 Audible warning On/Off button
4 Child lock activated symbol
5 On/Off button
6 Fan On/Off button combination
7 Fan On symbol
8 Interior light on/off button
Switching the appliance on and off
Switching the appliance on
Press the On/Off button until the temperature display
lights up.
Switching the appliance off
Keep the On/Off button pressed for approx. 3 seconds so that
the temperature display goes out.
Appliance dimensions
WKb 1812 A = 890 mm B = 613 mm C = 1172 mm
WKb 3212 A = 1350 mm B = 739 mm C = 1298 mm
WKb 4212 A = 1650 mm B = 739 mm C = 1298 mm
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal and
level.Compensate for uneven floors with the adjustable feet.
•
Do not cover ventilation openings
or grille.
• Standard EN 378 specifies that the room in
which you install your appliance must have
a volume of 1 m 3 per 8 g of R 600a refriger-
ant used in the appliance, so as to avoid the
formation of inflammable gas/air mixtures in
the room where the appliance is located in
the event of a leak in the refrigerant circuit.
The quantity of refrigerant used in your ap-
pliance is indicated on the type plate on the
inside of the appliance.
• Always install the appliance directly against
the wall.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!