Liebherr WKes 4552 GrandCru User Manual
Page 11
21
GB
28
30
31
32
34
33
28. Insert hinge pin.
29
29. Push in hinge pin until groove in
the pin lines up with bore hole in
the hinge bracket.
Front view of top hinge bracket
30. Undo screw in hinge pin and
screw into bore hole in hinge
bracket.
31. Place the appliance in its final position at the place of instal-
lation.
Extend the adjustable foot at the bottom hinge bracket until
it rests on the floor and then make a further 90° turn.
32. Release cover on the inside and slide
to the outside.
Adjusting the lateral tilt of the door
If the door is at an angle, adjust the angle.
Front view of top hinge bracket
33. Turn cover downwards.
34. Undo screws and slide hinge
bracket to the right or left.
Tighten screws.
Re-fit cover following the instruc-
tions above in reverse order.
Close door and check that it is
aligned with the side walls of the
appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.