Liebherr 200 DR 5-10 Litronic - Manual (Page 3)

r = 40 m
r = 60 m
4 5 4 5
Project planning – down to the last detail
Consultation and advice backed by skill and experience
are all part of the service. Our specialists will support
you in planning the best possible progress, even on the
most difficult sites.
• Site inspection (if required)
• Deciding on the best possible cranes for the job,
and the best place to put them
• Working out economical complete solutions
• CAD site planning, and optimization of assembly
progress
• Calculations of statics, connection values, ballasting
arrangements, etc.
Transport – there and back
We clear the way for your crane. We make sure that your
crane arrives safely where it’s needed, and exactly when it’s
needed.
• Transport logistics
• Loading to make assembly easy
• Transport out and back
Assembly and disassembly, the most economical
way possible
Highly qualified fitters carry out the assembly of your
Liebherr crane rapidly and in the most economical way
possible. The very latest special tools are taken right on
site, rounding out the Liebherr Rigging Concept.
• Assembly planning in advance
• Selection of the most economical mobile crane
• Assembly personnel with the best possible training
and the best possible experience
• Adjustment of overload prevention and safety devices
High standard
The 200 DR 5/10 Litronic derrick is
designed as standard with a hoist
drum for cable lengths of up to 633
metres. This means that disassembly
from even the highest sites is no
problem at all..
A Complete Service
Micromove
The powerful fine-sensitivity drive
units allow for the precise dismantling
of your crane, and positioning of
heavy loads with millimetric precision.