Superfrost, Defrosting, Cleaning – Liebherr CBNesf 5133 Comfort BioFresh NoFrost User Manual

Page 7: Shutting your appliance down, Malfunctions, Installing appliance in a row of kitchen units

Advertising
background image

15

GB

SuperFrost

By activating the SuperFrost function the temperature in the freezer

compartment will drop to the lowest attainable value. Thus food

can be rapidly frozen to the core and the quality is preserved.
Press the SuperFrost button

7

- the

LED in the button will come on.

• Wait 24 hours.
• Place the fresh food in the freezer.
• The automatic SuperFrost system automatically switches the fast

freezing procedure off after 65 hours.

You should not switch on the SuperFrost function:

- when placing frozen food in the freezer;

- when freezing up to approx. 2 kg fresh food daily.

6

Defrosting

Refrigerator compartment

The refrigerator compartment defrosts automatically. The water that

forms on the rear wall drains into a reservoir at the back of the appli-

ance and evaporates automatically through the compressor heat.

Freezer compartment

The NoFrost system automatically defrosts the appliance.

Any moisture arising collects on the evaporator and freezes, and

is periodically defrosted and evaporated.

Cleaning

Before cleaning always switch off the appliance. Pull out the

mains plug or remove/unscrew the fuse.
• Clean the side panels and door surfaces with a clean and soft cloth.

If necessary, use a moist cloth (water + detergent). Alternatively,

use a micro-fibre cloth.

- Do not use abrasive sponges or scourers, do not use concentrated

cleaning agents and never use cleaning agents containing sand,

chloride or acid or chemical solvents, as these would damage the

surfaces and could cause corrosion.

• Clean the inside and equipment parts with lukewarm water and

a little detergent.

Do not use steam cleaners because of the risk

of injury and damage.

• Ensure that no cleaning water penetrates into the electrical com-

ponents or ventilation grille.

• Dry all parts well with a cloth.
• Do not damage or remove the type plate on the inside of the ap-

pliance. It is very important for servicing purposes.

Shutting your appliance down

If your appliance is to be shut down for any length of time, switch

it off and disconnect the plug or switch off or unscrew the fuse.

Clean the appliance and leave the door open in order to prevent

unpleasant smells.

The appliance complies with the relevant safety regulations and

EC Directives 2004/108/EC and 2006/95/EC.

Malfunctions

If a malfunction occurs during operation, check whether it is due

to an operating error.
You may be able to rectify the following faults yourself:

Appliance does not function:

– Is the appliance switched on?

– Is the plug correctly fitted in the mains socket?

– Is the socket fuse intact?

Loud running noise:

– Is the appliance set up firmly on the floor?

– Does the appliance cause nearby items of furniture or objects to

vibrate? Please note that noises caused by the refrigerant circuit

cannot be avoided.

The temperature is not low enough:

– Is the temperature setting correct (see "Setting the temperature")?

– Have excessive amounts of fresh food been placed in the appli-

ance?

– Does the separately installed thermometer show the correct read-

ing?

– Is the ventilation system working properly?

– Is the appliance set up too close to a heat source?

If none of the above causes

apply and you cannot rectify

the fault yourself, contact the

nearest customer service de-

partment stating the type des-

ignation

1

, service number

2

and appliance number

3

as

indicated on the type plate.

The position of the type plate is shown in the section entitled

Description of the appliance.

Installing appliance in a row of kitchen units

To adapt the height of the appliance to the surrounding furniture

a top unit

1

can be added.

A gap of at least 50 mm

depth must be provided

behind and along the entire

width of this unit so as to

ensure sufficient ventila-

tion. The area of ventila-

tion underneath the ceiling

should be at least 300 cm

2

.

When setting up the ap-

pliance next to a wall

4

, a

distance of approx. 50 mm

must be provided on the

hinge side between the

appliance and the wall (for

the handle when the door

is open).

1

top unit

2

refrigerator-freezer

3

kitchen unit side panel

4

wall

Advertising