Liebherr LTM 1400-7.1 - Manual (Page 7)

PN 1400-7.1 DEFISR.fh11 24.07.2007 10:48 Uhr Seite 6
Probedruck
C M Y CM MY CY CMY K
7 6 LTM 1400-7.1 LTM 1400-7.1
• Crane engine: 6-cylinder Liebherr turbo-charged Diesel engine
type D936L A6 of 240 kW/326 h.p, exhaust gas emissions
in accordance with the directives 97/68/EG stage 3 and
EPA/CARB Tier 3, robust and reliable, electronic engine
management, optimated fuel consumption, exhaust gas
system of special steel
• Hydraulic system with 5 variable axial piston pumps with
servo-control and capacity regulation, auxiliary pumps for
central feeding and ventilator drive, electric driven oil cooler
• Standard high-efficiency noise absorption of the diesel-
hydraulic crane drive
Crane drive with field-proven
components
• Self-manufactured Liebherr winches (1, 2 and 3) with special
grooving, with incorporated planetary gears and spring-
mounted multi-disk brakes as static brakes
Winch 1
main hoist gear
Winch 2
auxiliary hoist gear, required for 2-hook operation with luffing
lattice jib
Winch 3
for variation of the luffing lattice jib
Auxiliary winch
for reeving of the hook block and for the erection of the lattice
luffing jib
• Drive of the hoist gear within a "closed oil circuit", i.e. during
lowering of the load, the oil motor is propping itself up on
the variable displacement pump due to the closed oil circuit
(hydraulic shaft). The potential energy is not converted into
heat, but can be re-employed for an additional movement.
Besides a saving in fuel, the hydraulic oil is less thermically
exposed than in an "open oil circuit"
• Axial-piston variable displacement motor of own manufacture,
specially laid out for crane operation, exposed to tough
fatigue test and field-proven
• Display of the rotary motion of the winch on the LICCON
display screen
• Non-rotating hoist rope, standard rotation absorber
• Video control of the winches (standard in conjunction with
the jib variation winch)
Winch technology by Liebherr
• 140 t total counterweight, 100 t basic counterweight,
40 t additional counterweight
• Hydraulic ballasting device on the counterweight frame
• "60-t-package" of just 3 m transport width, mountable by
one lift
• Hoist gear 2 fitted to the counterweight frame
• Jib variation winch (winch 3) to be pinned on the counterweight
frame
• The counterweight radius can be reduced from 6.6 m
to 5.6 m by the displacement of the entire counterweight
• Reeving winch (auxiliary winch) on the counterweight frame
as standard equipment
Counterweight assembly – just a
matter of minutes
Partial counterweight, radius 5.6 m 140 t total counterweight, radius 6.6 m
60 t-package with winch 3 Luffing jib mode, counterweight radius 5.6 m
or 6.6 m
Winch 1 Winch 2 Auxiliary
winch
Winch 3