Liebherr CN 5113 Comfort NoFrost - Manual (Page 7)

15
GB
Defrosting
Refrigerator compartment
The refrigerator compartment defrosts
automatically. The water that forms
on the rear wall drains into a reser-
voir at the back of the appliance and
evaporates automatically through the
compressor heat. Ensure that the wa-
ter can flow without hindrance through
the hole above the vegetable bins.
Freezer compartment
The NoFrost system automatically defrosts the appliance.
Any moisture arising collects on the evaporator and freezes, and
is periodically defrosted and evaporated.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the socket fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Have excessive amounts of fresh food been placed in the appli-
ance?
– Does the separately installed thermometer show the correct read-
ing?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service de-
partment stating the type des-
ignation
1
, service number
2
and appliance number
3
as
indicated on the type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.
Installing appliance in a row of kitchen units
To adapt the height of the appliance to the surrounding furniture
a top unit
1
can be added.
A gap of at least 50 mm
depth must be provided
behind and along the entire
width of this unit so as to
ensure sufficient ventila-
tion. The area of ventila-
tion underneath the ceiling
should be at least 300 cm 2 .
When setting up the ap-
pliance next to a wall
4
, a
distance of approx. 50 mm
must be provided on the
hinge side between the
appliance and the wall (for
the handle when the door
is open).
1
top unit
2
refrigerator-freezer
3
kitchen unit side panel
4
wall
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
Cleaning
Before cleaning always switch off the appliance. Pull out the
mains plug or remove/unscrew the fuse.
• First clean the side panels with a conventional stainless steel
cleaner. Subsequently, apply the enclosed stainless steel care
product evenly onto the surfaces in the same direction in with
they have been ground or polished.
• Only clean the door surfaces with a clean and soft cloth. If neces-
sary, moisten the cloth (water + detergent). Alternatively, use a
micro-fibre cloth.
- Do not use abrasive sponges or scourers, do not use concentrated
cleaning agents and never use cleaning agents containing sand,
chloride or acid or chemical solvents, as these would damage the
surfaces and could cause corrosion.
• Clean the inside and equipment parts with lukewarm water and
a little detergent.
Do not use steam cleaners because of the risk
of injury and damage.
• Ensure that no cleaning water penetrates into the electrical com-
ponents or ventilation grille.
• Dry all parts well with a cloth.
• Do not damage or remove the type plate on the inside of the ap-
pliance. It is very important for servicing purposes.