Britax ROUND ABOUT 50 - Manual (Page 37)

35
Child Seat Functions
Using the Locking Clip
Install child seat into vehicle using instruction
through step 5 on pages 16-21 for rear-facing,
or pages 22-27 for forward-facing.
NOTE: Clip is attached and stored on the back
of the seat.
1 Push the child seat firmly into the vehicle
seat while removing all slack first from the
lap portion of the vehicle belt, and then the
shoulder portion of the vehicle belt (Fig. A).
2 Hold the lap and shoulders belts together
just behind the latch plate and unbuckle the
vehicle belt without allowing the belt to slip
(Fig. A).
3 While holding the belts and latch plate,
thread the locking clip onto the seat belt
(Fig. B) and slide it into place near the latch
plate (Fig. C).
4 Buckle the seat belt with the locking clip in
place.
5 Verify that the seat belt is tight and the child
seat is secure.
• The child seat is secure when it cannot be
moved front-to-back or side-to-side more than
1 inch (2.5 cm.) at the belt path. If the child seat
is not secure, repeat the installation process or
use an alternate seating location.
IMPORTANT: Remove the locking clip from the
vehicle seat belt when not used with this child seat,
or the vehicle seat belt will not properly restrain a
passenger.
A
b
Locking
Clip
Latch Plate
C