Philips Lumea Comfort IPL Haarentfernungssystem - Manual (Page 18)

4 Move the appliance to another area and release a
flash at level 2. Continue to increase the intensity by
one level before releasing each next flash. Do not
release more than one flash in the same spot. Do not
increase the intensity beyond the maximum intensity
for your skin colour (see section ‘Skin colour and
light intensity’ in this chapter).
5 As soon as you experience any discomfort, reduce
the intensity level to the highest level at which there
was no discomfort.
6 Stop testing. Wait for 24 hours and then check your
skin for any reactions. If you see no skin reactions,
you can use the intensity level last used at your next
treatment of this body part.
Note: If your skin shows a reaction, wait for the reaction to
disappear. Then treat the body part at the intensity level below
the one that produced a reaction, wait for 24 hours and check
for skin reactions again.
7 Perform steps 1 to 5 for each body part you intend
to treat.
Using the appliance
Always perform a skin test (see chapter ‘Preparing for
use’) before you start using the appliance according to the
instructions below.
1 Insert the small plug into the appliance socket and
insert the adapter into a wall socket.
2 Press the on/off/intensity button. The light of
intensity level 1 goes on and the fan inside the
appliance starts.
ENGLISH 18