Belkin F5U234 - Manual (Page 8)

4
EN
4
Important Note: Please do not connect any USB devices to the Hub until
instructed to do so in step 4 of this installation procedure.
1. Plug the AC adapter into a wall outlet, or surge suppressor. Plug the DC
connector into the DC Power Jack found on the side of the Hub.
Important Note: The Hub may be used without the power supply when
connecting devices that draw 100mA of current or less, however, only port 1
and port 2 will be functional.
2. Plug the flat end of the provided USB device cable into the downstream
port of your computer or downstream port of another hub, then plug the
mini 6-pin connector of the device cable into the upstream port on the
rear of the Hub.
Important Note:The Hub must be connected to a USB 2.0-compliant host
in order to function in high-speed mode (480Mbps data rate). If the Hub is
connected to a USB 1.1-compliant host, it will operate only in low-speed or
full-speed mode (1.5Mbps/12Mbps).
3. Windows will now detect your Hub and install the required driver support.
(The Windows “Install New Hardware Wizard” may prompt you to provide
your Windows Installation CD to complete the driver installation process).
Important Note: High-speed hub drivers are included with most USB 2.0 PCI
upgrade cards, and are pre-installed along with the PCI card drivers. If you
purchased an upgrade card prior to the release of high-speed hub support,
please check with your PCI card vendor for an updated USB 2.0 driver. The
Belkin USB 2.0 driver supports all competitive cards based on the NEC host
controller with the exception of Adaptec. The most recent Belkin driver is
available at www.belkin.com.
Installation