Brocade BigIron RX Series Hardware Reference Manual - Manual (Page 140)

128 Brocade BigIron RX Series Hardware Installation Guide
53-1002483-03
Displaying flash memory and version information
6
Displaying version information
You can display version information for a BigIron RX Series switch using the e command as shown
in the following:
BigIron RX# show version
HW: BigIron RX Router
Boot-Monitor Image Indicates the boot image installed in the management module’s boot flash.
The image name format is described in
“Software image naming
conventions” on page 123. The output displays the following information
about the image:
•
Version – “2.3.0Txxy” indicates the image version number. The “Txxy”
is used by Brocade for record keeping. The “xx” indicates the hardware
type, while the “y” indicates the image type.
•
Size – The size, in bytes, of the image.
•
Check sum – A unique ID for the image. If the contents of the image
change, the check sum changes also.
•
Compilation date and time – The date and time that Brocade compiled
the image.
Interface Modules
Line Card Slot <number> The interface module for which flash information is displayed.
The <number> parameter indicates the number of the chassis slot, 1 – 16,
in which the interface module is installed.
Code Flash The model number and size of the interface module’s code flash.
IronWare Image (Primary or
Secondary) Indicates the IronWare image installed in the primary or secondary location
in the interface module’s code flash. The image name format is described
in
“Software image naming conventions” on page 123. The output displays
the following information about the image:
•
Version – “2.3.0Txxy” indicates the image version number. The “Txxy”
is used by Brocade for record keeping. The “xx” indicates the hardware
type, while the “y” indicates the image type.
•
Size – The size, in bytes, of the image.
•
Check sum – A unique ID for the image. If the contents of the image
change, the check sum changes also.
•
Compilation date and time – The date and time that Brocade compiled
the image.
Boot Flash The model number and size of the interface module’s boot flash.
Boot-Monitor Image Indicates the boot image installed in the interface module’s boot flash. The
image name format is described in
“Software image naming conventions”
on page 123. The output displays the following information about the
image:
•
Version – “2.3.0Txxy” indicates the image version number. The “Txxy”
is used by Brocade for record keeping. The “xx” indicates the hardware
type, while the “y” indicates the image type.
•
Size – The size, in bytes, of the image.
•
Check sum – A unique ID for the image. If the contents of the image
change, the check sum changes also.
•
Compilation date and time – The date and time that Brocade compiled
the image.
TABLE 23 Code flash and boot flash information (Continued)
This field... Displays...