Connecting ac power to a bigiron rx-8 chassis, Connecting ac power to a, Bigiron rx-8 chassis – Brocade BigIron RX Series Hardware Reference Manual User Manual
Page 53
Brocade BigIron RX Series Hardware Installation Guide
41
53-1002483-03
Installing a BigIron RX-8 switch
2
Connecting AC power to a BigIron RX-8 chassis
AC power is supplied through an AC power cord that is installed at the rear of the BigIron RX-8
chassis.
1. At the rear of the BigIron RX-8 chassis, locate the power receptacle where the power supplies
have been installed.
2. Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply.
3. Snap the cord-retainer over the power plug to hold it in place.
FIGURE 28
Connecting a power cord to the power supply in a BigIron RX-8 chassis
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.
4. For information about powering on the system, refer to
“Powering-on the power source”
1
Lift handle
3
Power cord
2
Cord retainer
4
Ground point
1
2
3
4