Important, Warning, Peration – Bissell PROHEAT 1425 User Manual

Page 6: Aintenance and care

Advertising
background image

16

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

6

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

Cleaning with your Auto Care

1. Hold the tool approximately 1” above the

soiled surface. Press the spray trigger to

apply the cleaning solution to the soiled area.

2. Using the brush on the tool, gently scrub the

area to be cleaned.

3. For thorough cleaning, spray additional

solution while the brush and suction are in

contact with the surface.

4. Apply downward pressure on the tool and

pull it toward you. The suction will remove

the dirt and cleaning solution. Continue until

no more dirt can be removed.

5. As a final step, use “drying strokes” (by not

pressing the spray trigger) to remove as

much liquid/moisture as possible. Repeat

this step as often as necessary.

After cleaning

1. Unplug power cord from outlet.

Note: If a significant amount of Little Green

formula/water remains, it is all right to leave it in

the clean/solution tank for your next cleaning task.

2. Empty and rinse the dirty/collection tank after

each use, OR when dirty water reaches the

indicated maximum fill line. To remove the

tank, lift up the dirty/collection tank release

latch and remove the tank from the unit.

3. Disconnect the cleaning tool from the spray

trigger by pushing down on button lock and

pulling straight off.

(Do NOT twist tool to remove it)

4. Once removed from the spray trigger, clean

tool by rinsing under running water.

5. Check spray nozzle for accumulated dirt or

debris. If necessary, clean with soft bristle brush.

Machine storage

1. Wipe all surfaces with a soft cloth.
2. Wrap power cord around the cord wrap on

the back of the Auto Care.

3. Wrap vacuum flex hose around the base of

the unit and secure the spray trigger.

4. Store unit in protected, dry area, at room

temperature (40º to 110ºF).

O

peration

M

aintenance and care

IMPORTANT:

Check the manufacturer’s tag before

cleaning upholstery. “W” or “WS” on the

tag means you can use your Auto Care. If

tag is coded with an “S” (with diagonal

strike-through), or says “Dry Clean Only,”

do not proceed. If manufacturer’s tag is

missing or not coded, check with your

furniture dealer.

Tip:

Deep cleaning

stairs and

high-traffic

areas on a

regular basis

can prolong

carpet life

.

Tip:

Check upholstery

stuffing before

cleaning. Colored

stuffing may

bleed through

the fabric when it

becomes wet.

Tip:

Before turning off the Auto Care,

vacuum up clean water to thoroughly

rinse out the interior of the vacuum

flex hose. Then, lift the cleaning tool

and point it upwards to drain any

remaining water into the dirty/

collection tank.

WARNING:

Keep spray away from face.

Failure to do so may result in

personal injury.

Tank Release
Latch

Advertising