Caution, Warning – Binatone MARINA 300 User Manual

Page 2

Advertising
background image

5.1 LCD Screen Back Light

Every time a button is pressed (except PTT button), the LCD

Screen back light will illuminate for 4 seconds.

5.2 Power Saving

Your PMR unit has special circuitry designed to extend the

life of your battery. When the unit is not used for 4 seconds,

it will automatically switch into a low power mode.

The Power Saving feature does not affect the PMR’s ability to

receive transmissions. When a signal is detected, it

automatically returns to full power mode.

5.3 Battery Meter Indicator

The PMR can detect the battery charge levels. The Battery

icon will display the battery charge status as follows;

Battery charge at high level.
Battery charge at low level.

Important: Replace the Batteries. Use only Alkaline

“AAA” 1.2V batteries.

5. Auxiliary Features

0 Range (Km) 3

Signal Strenght

Range Slope

Optimum (open area) (1)

Medium ground based

obstruction (2)
Heavily built up area (3)

The Transmission range of the product is dependent on the environment

terrain where it is being used, the following diagram attempts to guide

the user on the sort of performance to expect for everyday use.

Range Check

The Transmission range will be affected as shown in the above diagram.

The transmitting range typical values for different environment conditions

will be (1) 3 km (2) 1.5 km (3) 750m. It should be remembered that

these are only guide values as actual achieved distances will be

dependent on the environment and terrrain.

6. Effective Range

Binatone Help Line - 0845 345 9677

7. Specifications

8 Channels
0.5W

Up to 3 Kms. (2 Miles)

Channels Available
Output Power (TX)
Range

CAUTION

Damaged Antenna

Do not use any PMR that has a damaged antenna. If a damaged antenna comes

in contact with the skin, a minor burn may result.

Potentially Explosive Atmospheres

Turn your PMR OFF when in any area with a potentially explosive atmosphere , unless

it is a type especially qualified for such use ( for example, Factory Mutual Approved).

Sparks in such areas could cause an explosion or fire resulting in injury or even death.

Batteries

Do not replace or charge batteries in a potentially explosive atmosphere. Contact

sparking may occur while installing or removing batteries and cause an explosion.

WARNING

For Vehicles with an Air Bag

Do not place your PMR in the area over an air bag or in the air bag deployment area.

Air bags inflate with great force. If a PMR is placed in the air bag deployment

area and the air bag inflates, the PMR may be propelled with great force and

cause serious injury to the occupants of the vehicle.

Batteries

All batteries can cause property damage and/or bodily injury such as burns if

conductive material such as jewelry, keys, or beaded chains touch exposed

terminals. The material may complete an electrical circuit (short circuit) and

become quite hot. Exercise care in handling any charged battery, particularly

when placing it inside a pocket, purse, or other container with metal objects.

8. Safety

NOTE: Areas with potent ially explosive atmospheres are often, but not always ,

clearly marked. They incl ude fueling areas such as belo w deck on boats; fuel or

chemical transfer or sto rag e faci lities; areas where the air contains chemica ls or

particles, such as grain , dust, or metal po wders; and any other area where you
would nor mal ly be advised to turn off your vehicle engine .

Blasting Caps and Areas

To avoid possible interference with blasting operations, turn your PMR OFF near

electrical blasting caps or in a “blasting area” or in areas posted: “Turn off the two-

way radio.” Obey all signs and instructions.

9. Cleaning and Care

To clean your PMR, use a soft cloth dampened with water. Do not use cleaners or

solvent, which may cause damage that may not be covered by guarantee.

Channel Frequency Table

8

446.05 625
446.06 875
446.08 125

Channel

1
2

3
4

5
6
7

446.00 625
446.01 875
446.03 125
446.04 375

446.0 9375

Frequency (MHz)

Channel

Frequency (MHz)

Binatone Help Line - 0845 345 9677

Symptom

Solution

No power.

Reception

is weak.

Cannot change

channels.

Range is limited.

Wearing the radio close to the body, such as in a pocket or on

a belt, will decrease range; change the location of the radio.

limit the range significantly.

may

Open fields provide the maximum range, while steel/concrete

structures, heavy foliage, and use in buildings and in vehicles

The maximum range will vary depending on terrain and environment.

Replace with new

if the battery charge level

indicator is low.

batteries

Batteries may be weak.

Sound distortion

problems.

Radios too far apart. Obstacles interfere with transmission.

Talk range is up to 3 Km (2 miles) in clear unobstructed

conditions.

Radios too close. Radios must be at least 1.5 meters apart;

your distance.

increase

If you are transmitting, speak in a normal tone of voice, 5 cm

away from the Mic (microphone.).

If you are receiving, lower the volume to a comfortable level.

11. Troubleshooting Guide

The

may be weak.

batteries

Check the batteries are installed properly.

Replace the old batteries with new ones.

Binatone Help Line - 0845 345 9677

Press the (UP) button to increase the receiver volume level.

The receiving signal may be weak and/or out of range.

Key lock mode must be deactivated if the Key lock icon ( ) is

displayed on the LCD Screen.

To change channels, press the MENU button then press the

(UP) or (DOWN) buttons to change the current channel.

Batteries may be weak.

Binatone Telecom plc operates a policy of continuous product

improvement, and so reserves the right to make changes to the product

and functions without prior notice.

Declaration of Conformity

And conforms to the following relevant standards:

The Binatone marina

300

complies with the essential requirements

Waste electrical products must not be

disposed of with household waste.

This equipment should be taken to

your local recycling centre for safe

treatment.

The Binatone marina 300 is fully guaranteed for 12 months from the date

purchase shown on you r sales receipt. The guarantee does not cover

damage by misuse or negligence, or by excessive voltage.

10. Guarantee and service

When unpacking your Binatone marina 300, check for visible damage.

If you see any damage, do not use the PM R - return the whole unit to

where you bought it.

If your Binatone marina 300 develop

s a fault, refer to the “ Troubleshooting

Guide.” section of this manual. If you can’t solve the problem, return the

whole unit as follows;

Repair after the Guarantee has expired

If the unit is no longer covered by Guarantee, first follow steps 1 as for

repair under Guarantee, Then...

2. Call our service Department on 0845 345 9677 and ask for a

quotation of the repair charge, and details of where to send your

M

300

for repair.

3. Return your marina

300

to the address given by the Service Department,

making sure to include your name and address, and a cheque or

postal order for the value of the repair charge.

This does not affect your statutory rights.

Binatone Telecom plc operates a policy of continuous product

improvement, and so reserves the right to make changes to the product

and functions without prior notice.

Please keep your sales (till) receipt - this is your guarantee. You should

also keep the original packaging materials.

This equipment is intended for use in:

Austria

Finland

Latvia

Denmark

Ireland

Portugal

Estonia

Italy

Slovenia

Spain

Belgium

France

Liechtenstein

Sweden

Bulgaria

Germany

Luxemburg

Switzerland

Croatia

Greece

The Netherlands

Turkey

Cyprus

Hungary

Norway

UK

Czech

Iceland

Poland

Romania

Countries of use

Caution: Use only same type and make of batteries. To reduce the

risk of electric shock, do not expose this appliance to rain or

moisture.

marina 300

marina 300

of

Advertising