Baby Trend Sit n Stand Plus 11.07 - Manual (Page 6)

SEATBACK POSITIONING
1. The front seat has a two position recline. To recline the seat, rotate the
recline bar and press backward on the seat back. Fig. 19. To place the
seat in the upright position, press upward on the seat back while rotating
the recline bar.
2. The upright position should be used only for a child that is at least 6
months old. Note: Seat does not fully recline.
3. To recline the rear seat locate the plastic adjuster and squeeze the ends.
Loosen or tighten the strap to your desired recline position. Fig. 20.
TO RECLINE SEATS
Fig. 19.
Fig.20.
6
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
STEP TWO: INSTALLING JUMP SEAT PAD (if equipped)
1. Slide the Pad over the front of the Jump Seat platform and into the front
pocket of the Pad cover.
2. Insert the safety harness, crotch strap through the Pad in the
slot provided.
3. Fold the Pad over the seat and secure conneting the straps together.
4. Have child sit on the jump seat facing backwards. Secure the seat belt,
which is attached to the back of the seat, around the child’s waist, and
buckle to the crotch strap. Fig. 12B. Adjust the seat belt to be snug around
the child’s waist.
5. To release, apply pressure to both sides of the male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child.
6. Be sure that the child’s feet are fully on the platform at all times.
When you are not using the jump seat harness, place it in the storage location
on the rear of the front seat. Fig. 18
D-ring
Fig. 16
Fig. 17
Fig. 18
Fig. 15