B&C Speakers 12 PS 32 - Manual

Speakers
HPL
Coaxials HF Compression drivers Horns
Specifications
Nominal Diameter 320 mm (12 in)
Nominal Impedance 8 Ω
Minumum Impedance 7.2 Ω
Power Handling
(60 –600 Hz)
Nominal
1 700 W
Continuous Program 2 1400 W
Sensitivity (1W/1m) 3 94 dB
Frequency Range 45-2000 Hz
Voice Coil Diameter 100 mm (4 in)
Winding Material Aluminium
Former Material Kapton
Winding Depth 18.5 mm (23/32 in)
Magnetic Gap Depth 8.5 mm (11/32 in)
Flux Density 1.1 T
Thiele & Small Parameters 4
Fs 44 Hz
Re 5.9 Ω
Qes 0.39
Qms 3.2
Qts 0.35
Vas 82 dm 3 (2.9 ft 3 )
Sd 522 cm 2 (80.9 in 2 )
η
0 1.8%
X max ± 6 mm
X var ± 7.5 mm
Mms 60 g
Bl 15.9 T·m
Le 1.8 mH
Mounting and Shipping Information
Overall Diameter 319 mm (12.5 in)
Bolt Circle Diameter 299 mm (11.8 in)
Baffle Cutout Diameter 282 mm (11.1 in)
Depth 120 mm (4.7 in)
Flange and Gasket Thickness 16 mm (5/8 in)
Net Weight 9.3 kg (20.5 lb)
Shipping Weight 10.4 kg (22.9 lb)
Shipping Box 380x380x170 mm
(15x15x6.7 in)
1 2 hours test made with continuous pink noise signal (6 dB crest factor) within the
specified range. Power calculated on rated minimum impedance. Loudspeaker in
free air.
2 Power on Continuous Program is defined as 3 dB greater than the Nominal rating.
3 Applied RMS Voltage is set to 2.83V for 8 ohms Nominal Impedance. Average
SPL from 200 to 2500 Hz.
4 Thiele-Small parameters are measured after a high level 20 Hz sine wave precon-
ditioning test.
12 PS 32 |
Woofer
This 12" woofer with 1400W maximum power handling is
recommended for the most demanding sound reinforcement
application. A special 4" voice coil using proprietary high
temperature adhesives and an optimized magnet assembly
guarantee a very good LF dynamic range with a very low
distortion figure Sub compact reflex systems set new standards
employing the ultra high power 12 PS 32.