Black Box NBC27XB - Manual (Page 10)

Page 10 724-746-5500 | blackbox.com
Chapter 4: Configuration and Setup
4.2 Fastening Power Bricks to the Dividers
Attach power bricks to the dividers to create separate slots for the netbooks.
Remove a divider to install a netbook power brick on the divider.
Step 1. Lay the divider flat on the work surface. Lay a netbook and a power brick on
top of the divider, with the computer end of the power wire toward the top of the
divider. Plug the power brick into the netbook. Lay the wire across the two holes at
the top of the divider. Make sure that there is some slack between the front hole and
the plug.
Make sure there
is slack at these
two points
Netbook
Cord slack
Note this point
Power Brick
Align the back of the netbook
with the back of the divider
Figure 4-3. How to thread the electrical cable through the dividers.
Step 2. Note the point where the power wire meets the rear hole in the divider.
Measure back 6" toward the power brick and fold the wire in half to create a loop in
the center of the wire. This loop will be used in Step 3, page 11. Unplug the power
wire from the netbook and remove the netbook from the divider.
Figure 4-4. Loop the electrical cord and push it through the circular hole at the top
rear of the divider.
NBC20S