Philips HAIRCLIPPER Series 1000 Haarschneider - Manual (Page 8)

The charging light does not go out or change colour when the
appliance is fully charged.
optimising the lifetime of the battery
After the appliance has been charged for the first time, do not recharge it
between clipping sessions. Continue to use it and recharge it only when
the battery is (almost) empty.
Discharge the battery completely twice a year by letting the motor
run until it stops.
Do not keep the appliance plugged into a wall socket all the time.
If the appliance has not been used for a long time, it must be
recharged for 8 hours (NiCd battery) or 12 hours (NiMh battery).
Corded clipping
QC5050 only:
Do not run the appliance from the mains when the battery is fully
charged.
To use the hair clipper connected to the mains: switch the hair
clipper off, connect it to the mains and wait a few seconds before
switching it on.
QC5010 only:
1 Insert the appliance plug into the appliance. (Fig. )
 Insert the adapter into the wall socket.
using the appliance
Clipping with comb attachment
The hair length after cutting is indicated in millimetres on the display.
The settings correspond to the remaining hair length after cutting.
The hair length after cutting is only visible when the comb is attached.
1 Slide the comb attachment into the guiding grooves of the
appliance (‘click’). (Fig. 5)
-
-
-
,
-
-
English 8