Brother DCP1000 - Manual

– 1 –
Press and slide
Load the paper
with the lever down
THANK YOU!
CONGRATULATIONS ON PURCHASING THE ULTIMATE
BROTHER MACHINE.
WE ARE SURE YOU WILL BE THRILLED WITH THE
CONVENIENT WAY YOUR NEW MACHINE PERFORMS SO MANY
TASKS WITH DAZZLING RESULTS!
Follow these simple instructions in numerical order.
For more details, press Reports and on your machine or see
your Owner’s Manual.
If you cannot solve a problem:
Refer to Frequently Asked Questions (FAQs) on Brother World
Wide Web;
URL: http://solutions.brother.com
Call Brother Customer Service at:
USA: 1-800-284-4329 (9AM-5PM EST)
1-800-284-3238 (TTY service for the
hearing impaired)
In Canada: 1-877-BROTHER (8AM-8PM EST)
1-514-685-6464 (in Montreal)
1
Packing List
Keep the packing materials for possible future transport. If you do not pack the machine properly, it may
void your warranty.
Power Cord
Drum Unit Assembly
With Free Starter
Toner Cartridge
(Up to 1000 pages)
CD-ROM
Paper
Support
Warranty
Registration
(For USA Only)
Software
License
Agreement
Accessory
Order Form
Owner’s Manual
Quick Setup Guide
Filter Core for
Bi-directional
IEEE 1284
Filter Core for
USB Cable
Cable Tie
2
Install the Drum Unit
5
Install Power Cord
3 Attach the Plastic Supports
and Pull out the Paper Tray
4
Load Paper
A. Unpack the drum unit assembly, and gently
rock it from side to side five or six times to
distribute the toner evenly inside the cartridge.
D. Close the scanner cover.
A. Adjust the guides to the position for the paper
size you are using.
B. Fan the paper well.
B. Open the scanner cover of the machine by
pulling the lever toward you and lifting the
cover.
To prevent damage to the drum, do not
expose it to light for longer than a few
minutes.
Do NOT remove the clear plastic starter
sheet-this will be ejected while the DCP is
warming up.
Starter Sheet
A. Attach the plastic paper
support to the
multi-purpose sheet feeder.
B. Pull out the paper tray and
the extension.
C. If your paper size is A4 or
Letter, unfold the paper
stopper by pulling it toward
you.
C. Holding the drum unit by its handles, insert it
into the DCP.
(For legal paper)
(For A4/Letter paper)
version B
DCP-1000
Quick Setup Guide
Turn the power switch OFF.
Do Not connect the Parallel or USB Cable.
C. Push down the paper lever. Load the paper
(with the lever down). Make sure the print side
is toward the DCP and the paper level is
stacked below the paper mark. The feeder can
hold up to 200 sheets of paper, or up to 10
envelopes.