Vitek VT-1373 - Manual (Page 6)

6
Rechargeable shaver for dry shav-
ing with three floating shaving
heads
Parts list
1. Protective cap
2. Shaving block
3. Blade drive
4. Shaving block locking button
5. Shaver body
6. Power switch with blocking button
7. Charging indicator
8. Charger
9. Cleaning brush
10.Travel bag
Charging (Pic.1)
Before first using the shaver or after
long periods of disuse, the batteries
must be charged for 4 hours.
- Connect the charger plug (8) to the
jack on the bottom of the shaver
body and connect the charger to
AC power; the charging indicator
will light.
- Consequent charging cycles
should not exceed two hours.
Attention!
- Do not charge the batteries for
more than 10 hours and in temper-
atures less than 0°Ñ or more than
40°Ñ as this can lead to a reduction
in charge capacity.
- If you don't use the shaver for more
than 20 days, charge it for four
hours.
Using the shaver
The best shaving results are achieved
if your skin is dry.
Your skin may need 2-3 weeks to
adapt to this shaving system.
- Remove the protective cap (1).
- Turn on the switch (6).
- Lightly touch the skin, moving
around the shaving block using
simultaneous up-down and rotat-
ing motions.
- Turn off the shaver with the power
switch (6), cover the shaving block
with the protective cap (1) and
store the shaver.
Using the trimmer (Pic. 2, 3)
The trimmer is designed for evening
whiskers and caring for mustaches.
- Move the trimmer switch (13) to
the upper position.
- Turn on the shaver with the switch (6).
- Position the shaver at the correct
angle to the skin and move it grad-
ually down, evening the whiskers.
- Turn off the shaver and move the
trimmer switch (13) to the lower
position.
Cleaning the shaver
- Press the shaving block locking
button (4) and remove it (Pic. 4, 5).
- Using the brush (9), clean the
shaving block inside and out, and
also the blades (Pic. 6, 7).
- Replace the shaving block, cover
with the protective cap and put
away.
ENGLISH
Vt-1373.qxd 24.01.05 12:46 Page 6