Belshaw Brothers TG 50 - Manual (Page 22)

Belshaw Bros., Inc.
• 1750 22 nd Ave. S.
• Seattle, WA 98144 • Phone 206-322-5474 • Fax 206-322-5425
16 MN-1716EN Thermoglaze 50
Cleaning
1. Hand wash all parts of the oven and
glazer with warm soapy water.
2. Do not use caustic cleaners on oven parts.
3. You may use an approved oven cleaner
on the stainless steel finger cover only.
(see step 27 of Disassembly)
4. Do not use oven cleaner on any other part
of the oven or glazer!
5. Do not hose/spray down any part of this
machine.
6. Glaze pump body and parts.
CAUTION
Failure to properly clean or lubricate glaze
pump may cause damage to the pump gear
impellors.
Assembly
NOTE
Lubricate the pump body, shaft “o” ring and
gear impellors with food grade mineral oil.
1. Install the glaze pump body.
2. Install the drive gear impeller. Line up
the flat on the shaft with the flat in the
impeller.
3. Install the lay gear impeller.
4. Install the “O” ring into the glaze pump
cover. Make sure it stays in place and you
do not pinch it between the pump and
cover. The “O” ring may need to be
stretched before installing.