Briggs & Stratton INTEK AND QUANTUM 110000 User Manual

Page 7

Advertising
background image

Document: - page 7 (Black)

Screen angle and frequency: 45.0000, 150.0000

7

OIL

275054

CAUTION:

This engine is shipped from Briggs & Stratton

without oil. Check oil level before starting engine. If

you start the engine without oil, the engine will be

damaged beyond repair and will not be covered

under warranty.

OIL CAPACITY
Engine holds approximately 5/8 quart (20 ounces; 0.6 liter).
TYPE OF OIL TO USE

• Use a high quality detergent oil classified “For Service

SF, SG, SH, SJ” or higher, such as Briggs & Stratton

30W, Part Number 100005 (20 oz) or 100028 (48 oz).

• Do not use special additives.
• Choose a viscosity according to the table opposite.

Note: Synthetic oil meeting ILSAC GF-2, API

certification mark and API service symbol

(shown at left) with “SJ/CF ENERGY CON-

SERVING” or higher, is an acceptable oil at all

temperatures. Use of synthetic oil does not

alter required oil change intervals.

°

F -20

0

20

40

60

80

100

°

C -30

-20

-10

0

10

20

30

40

STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

*

**

32

* CAUTION: Air cooled engines run hotter than

automotive engines. The use of non-synthetic

multi-viscosity oils (5W-30, 10W-30, etc.) in

temperatures above 40

° F (4° C) will result in higher

than normal oil consumption. When using a

multi-viscosity oil, check oil level more frequently.

** CAUTION: SAE 30 oil, if used below 40

° F (4° C), will

result in hard starting and possible engine bore

damage due to inadequate lubrication.

SAE Viscosity Grades

ADDING OIL

[1] Place engine level and clean around oil fill area.

[2] Remove dipstick and

wipe clean with cloth.

[3] Replace and tighten dip-

stick. Remove and

check oil level.

Oil Fill

[4] Oil level should be at

FULL line on dipstick.

[5] If needed, add oil slowly -

recheck.

Do not over fill.

[6] Replace and tighten dip-

stick.

CAUTION:

Do not overfill. Overfilling with oil may cause:

Smoking,

Hard starting,

Spark plug fouling, or

Oil saturation of air filter.

• Check oil level before starting the engine.
• Check level daily, or after every eight (8) hours.
• Keep oil level at FULL.

See also Maintenance section for instructions on

changing oil and scheduled maintenance intervals.

• Smoking,
• Hard starting,
• Spark plug fouling,
• Oil saturation of air

filter.

KEEP SPARK PLUG UP

CAUTION:

If engine is tipped to transport equipment, remove

grass, drain oil, etc., keep spark plug side of

engine up. Tipping engine with spark plug down

may cause:

Advertising
This manual is related to the following products: