Philips Lumea Precision Plus IPL Haarentfernungssystem - Manual (Page 29)

Problem Possible cause Solution
The ‘ready to flash’ light is
green but the appliance
does not produce a flash
when I press the flash
button.
The appliance
needs to be reset.
To reset the appliance, switch off the appliance and
switch it on again. If the ‘ready to flash’ light is green
but the appliance still does not produce a flash when
you press the flash button, contact the Consumer Care
Centre in your country, your Philips dealer or a Philips
service centre.
The appliance becomes
warm during use.
This is normal. No action required.
The appliance does not
show light intensity 1
when I switch it on.
The appliance
needs to be reset.
To reset the appliance, switch it off and on again. If the
appliance still does not show light intensity 1, contact
your Customer Care Centre, your Philips dealer or a
Philips Service Centre.
The appliance produces
a strange smell.
The attachment
and/or the filter
glass is dirty.
Clean the attachment carefully. If you are unable to
clean the attachment properly, contact the Consumer
Care Centre in your country, your Philips dealer or a
Philips service centre to replace the attachment.
You have not
shaved the area
to be treated
properly.
If there are hairs on the area to be treated, these
hairs may get burnt when you use the appliance. As
a result, you notice a strange smell. Shave the area to
be treated properly before you use the appliance. If
shaving causes skin irritation, trim hairs as short as
possible and use a comfortable setting.
You stored the
appliance in a
dusty environment.
The strange smell disappears after a few flashes.
The skin feels more
sensitive than usual
during treatment.
The light intensity
you use is too high.
Check if you have selected the right light intensity. If
necessary, select a lower light intensity.
You did not shave
the areas to be
treated.
Shave the areas to be treated before you use the
appliance. If shaving causes skin irritation, trim hairs as
short as possible and use a comfortable setting.
The UV filter
of the light exit
window is broken.
If the UV filter of the light exit window is broken, do
not use the appliance anymore. Contact the Consumer
Care Centre in your country, your Philips dealer or a
Philips service centre.
The appliance is
defective.
Contact the Consumer Care Centre in your country,
your Philips dealer or a Philips service centre.
I experience an
unacceptable pain
sensation when I use the
appliance.
You did not shave
the areas to
be treated
Shave the areas to be treated before you use the
appliance. If shaving causes skin irritation, trim hairs as
short as possible and use a comfortable setting.
You treated an
area for which the
appliance is not
intended.
You must not use the appliance on your inner labia,
vagina, anus, nipples, areolas, lips, inside the nostrils and
ears, in the region of your eyes and eyebrows. Men
must not use it on their face or scrotum.
EngliSh 29